Cart
Your cart is empty
Add products to get started
Custom kitchen cabinets made to measure for HDB flats, condos and landed homes. Top and bottom cabinets, tall units, countertops and hardware, built and installed by one team.
The kitchen is the hardest-working room in a Singapore home. Cabinets get opened dozens of times a day, sit next to heat and water, and have to fit a lot into a small space. Cabinets that are badly measured or built from the wrong board start to sag, swell and lose their doors within a few years. MK Renovation designs, builds and installs kitchen cabinets for HDB flats, condominiums, landed homes and small offices across Singapore. Every set is made to measure from your actual walls, pipes and power points, so the cabinets fit the space instead of the other way round. We plan the layout around how you use the kitchen: where the sink, hob and fridge go, how much drawer space you need, and where tall items like rice cookers and air fryers will live. Then we confirm board, finish, countertop and hardware with you before anything is fabricated. Moisture is the main enemy of kitchen cabinets, so we use water-resistant boards for sink cabinets and areas near the wet zone, seal exposed edges and leave proper gaps for ventilation around appliances. We also replace cabinet doors, hinges and countertops, repair sagging or water-damaged units and give tired kitchens a new look with refacing, so you do not always need a full new kitchen to get a good result.
Tap any item to request a quote for it
Top (wall) cabinets
Wall cabinets built to your ceiling height, with space planned for the cooker hood, lighting and the items you reach for every day.
Bottom (base) cabinets
Base cabinets for the sink and hob with drawers, pull-outs and corner solutions, built on water-resistant board where it matters.
Tall units and appliance housing
Full-height units for the fridge, oven, microwave and pantry storage, so appliances sit flush and the kitchen looks built-in.
Countertops
Quartz, solid surface and compact laminate tops cut to size, with openings for the sink and hob and neat edges and joints.
Soft-close hardware
Soft-close hinges and drawer runners, handles or handleless profiles, plus organisers like cutlery trays and dish racks.
Door replacement and refacing
New doors and laminates on sound existing carcasses. A quicker, lower-cost way to give an old kitchen a fresh look.
Cabinet repair
Sagging doors, broken hinges, loose drawers and water-swollen panels fixed or replaced so the kitchen works properly again.
Remove and dispose old kitchen
Old cabinets and tops removed carefully, debris cleared from the unit and disposed of, ready for the new kitchen.
The details we check on every job
We measure the actual walls, floor levels, pipes and power points. Walls are rarely perfectly straight, so the cabinets are planned around the real space.
Sink cabinets and units near the wet area use water-resistant board with sealed edges, so a small leak does not turn into swollen, peeling panels.
Drawers for pots, pull-outs for bottles, corner solutions and space for small appliances, planned around what you actually keep in the kitchen.
Soft-close hinges and full-extension runners rated for daily use. Doors are adjusted so gaps are even and everything closes quietly.
Proper clearance around the hob, oven and fridge, and room for the cooker hood ducting, so appliances work safely and cabinets do not overheat.
Edges sealed, doors aligned, shelves wiped down and debris cleared. We walk through every drawer and door with you before handover.
Not every kitchen needs to be torn out. The right choice depends on the condition of your existing cabinets, your budget, how long you plan to stay and how much disruption you can accept. We check the carcasses, hinges, countertop and the area under the sink before suggesting an option.
When the cabinets are water-damaged, the layout no longer works or you are renovating a new or resale flat, a full new kitchen gives the best result. We remove the old units, check the plumbing and electrical points, and build new top and bottom cabinets, tall units and countertop to a layout planned with you. It is also the right time to move the sink or hob, add power points and fit a new cooker hood.
If the carcasses are solid and dry but the doors look dated, refacing replaces only the doors, drawer fronts and visible panels. You get a new colour and finish for much less than a full kitchen, with less mess and a shorter job. New handles or handleless profiles and soft-close hinges can be added at the same time.
A stained, chipped or burnt countertop can be replaced without changing the cabinets. Quartz is popular for its hard, low-maintenance surface, solid surface allows seamless joints and compact laminate keeps cost down. We take templates on site so the new top fits tightly against the walls, and re-fit the sink and hob afterwards.
Sagging doors, sticking drawers and hinges that no longer hold are common in older kitchens. Replacing hinges and runners with soft-close hardware and adjusting the doors often makes a kitchen feel new again. Panels swollen by water from a leaking sink are replaced, and we check the leak source so it does not happen again.
Cabinet boards and finishes affect both the look and how long the kitchen lasts. We use water-resistant board for wet areas and explain the difference between laminate, solid colour and wood-grain finishes so you can choose what fits your budget and style. Before fabrication you see and approve the finish, the countertop and the hardware.
From measuring to a working kitchen
Send photos on WhatsApp or book a site visit. We measure the space and note the sink, hob, power points and any plumbing that may need to move.
You get a layout and a clear quote covering board, finish, countertop and hardware. Once agreed, we schedule fabrication and installation.
Cabinets are made to measure, then installed level and secured to the wall. The countertop, sink and hob openings are fitted on site.
Doors and drawers are aligned, edges sealed and the kitchen cleaned. We walk through every unit with you before handover.
Straight answers from our team. Still unsure? WhatsApp us.
It depends on the size of the kitchen and the finishes chosen. After the layout and quote are agreed, fabrication usually takes a couple of weeks and installation on site often takes a few days. We give you a realistic timeline in the quote.
We recommend water-resistant board for the sink cabinet and areas near water, with sealed edges. For the rest of the kitchen we explain the board and finish options so you can balance cost and durability. You approve the materials before fabrication.
Yes. If the cabinet carcasses are dry and solid, we can replace just the doors and drawer fronts. Refacing gives the kitchen a new look for less cost and less mess than a full new kitchen.
Yes. We supply and install quartz, solid surface and compact laminate countertops cut to site templates, with openings for the sink and hob. We can also replace only the countertop on existing cabinets.
Yes. We replace swollen or damaged panels and the cabinet base, and check the sink, pipes and connections so the leak is fixed at the source. Our plumbing team can handle the pipe work in the same visit.
Yes. We dismantle the old cabinets and countertop, protect the floor and walls, and clear the debris from your unit as part of the job.
Send photos and rough measurements on WhatsApp and we will suggest a layout and a quote.
Tell us about your kitchen. You can also send photos on WhatsApp after you submit.
Sample kitchen styles for inspiration. Photos of our own kitchen projects are coming soon.
